GE IC695ETM001-EH Ethernet Interface

The GE IC695ETM001-EH connects PACSystems RX3i controllers to industrial Ethernet networks. This interface module supports high-speed data exchange between PLCs and HMIs. You will find it in automated factories and process control systems. It handles SRTP, Modbus TCP/IP, and EGD communication protocols. Therefore, this module enables seamless integration with enterprise networks.

This module measures 140 mm in height and 35 mm in width. Its depth reaches 120 mm for standard RX3i rack mounting. The unit weighs approximately 0.32 kilograms. It contains one 32-bit processor with 16 MB of RAM. Two RJ-45 Ethernet ports provide copper network connections. Additionally, you get eight status LEDs for network diagnostics.

Key Technical Specifications

Parameter	Value
Manufacturer	GE Intelligent Platforms
Model	IC695ETM001-EH
Product Type	Ethernet Interface Module
Network Ports	2 (RJ-45, 10/100 Mbps)
Supported Protocols	SRTP, Modbus TCP/IP, EGD
Processor	32-bit @ 200 MHz
Memory	16 MB RAM, 8 MB Flash
Maximum Connections	64 simultaneous
Web Server	Built-in diagnostic pages
Height	140 mm
Width	35 mm
Depth	120 mm
Weight	0.32 kg
Status LEDs	8 (PWR, OK, LAN1, LAN2)
Energy Storage	≈ 200 µF (capacitive)
Power Consumption	350 mA @ 3.3 VDC
Operating Temperature	0°C to +60°C
Mounting Method	RX3i backplane

Internal Architecture and Energy Storage

The GE IC695ETM001-EH stores minimal energy in its power filter section. Small electrolytic capacitors hold approximately 200 microfarads total capacitance. A 32-bit processor runs at 200 MHz for fast packet processing. This processor handles all TCP/IP stack operations independently. Two independent Ethernet controllers manage each port separately. The module includes 16 MB of RAM for packet buffering and caching. Eight MB of flash memory stores firmware and web pages. An onboard real-time clock maintains time during power cycles.

Connection Interfaces and Wiring Details

You will find two standard RJ-45 jacks on the front panel. Port 1 supports auto-crossover and auto-negotiation at 10/100 Mbps. Port 2 provides the same features for daisy-chaining or redundancy. Use Category 5e or better shielded twisted-pair cable. Connect the module to an Ethernet switch for network access. The GE IC695ETM001-EH supports both straight-through and crossover cables automatically. Eight LEDs indicate power, module health, and link activity. Green LEDs show active network links while yellow LEDs show data transmission.

Configuration and Installation Steps

You slide this module into any slot of the RX3i backplane. First, align the module with the upper and lower card guides. Then, push it firmly until the backplane connector seats completely. Secure the front panel with the two retaining screws. Use the PACSystems Machine Edition software to configure IP settings. Assign a unique IP address, subnet mask, and gateway address. The GE IC695ETM001-EH obtains its configuration from the CPU on startup. Access the built-in web server for diagnostic information. Type the module’s IP address into any web browser. Verify link activity on both ports before deploying the system.