MeloAuto-Trusted PLC & DCS Parts Supplier
The GE DS200SNPAH1A DS200SNPAH1ABB SNP protocol interface board enables legacy serial communication for GE Mark V systems. This board translates between the backplane bus and SNP serial networks. You will find this interface board in turbine control cabinets and legacy HMI connections. Its robust design supports reliable long-distance serial communication.
Protocol Conversion Architecture
This SNP interface board uses a dedicated UART processor for serial handling. Consequently, it offloads protocol conversion tasks from the main CPU. The GE DS200SNPAH1A DS200SNPAH1ABB supports both point-to-point and multi-drop network configurations. Moreover, selectable termination resistors simplify network setup. You can connect this board to older GE control systems easily.
Technical Specifications
| Parameter | Value |
|---|---|
| Serial Ports | 2 (one RS-232, one RS-485) |
| Supported Protocol | GE SNP (Serial Network Protocol) |
| Baud Rate | 300 to 19.2 kbps (software selectable) |
| Data Format | 8 data bits, 1 stop bit, no parity (configurable) |
| Input Voltage | 24V DC ±10% |
| Power Consumption | 5W typical |
| Dimensions | 180mm x 120mm x 25mm |
| Weight | 0.32 kg (0.71 lbs) |
| PCB Layers | 4 |
| Onboard Components | 1 UART, 2 serial drivers, 4 optocouplers, 2 termination resistor packs |
| Connector Count | 4 (power, RS-232, RS-485, backplane) |
| Status Indicators | 4 LEDs (power, TX, RX, fault) |
| Energy Storage | 470 µF (power filtering capacitance) |
| Isolation Voltage | 1500V (serial ports to logic) |
| Maximum Cable Length | 15m (RS-232), 1200m (RS-485) |
| Operating Temperature | 0°C to +50°C |
| Storage Temperature | -20°C to +70°C |
Dual Port Connectivity and Isolation
The unit includes both RS-232 and RS-485 physical interfaces. Therefore, you can connect to either local devices or long-distance networks. This board replaces the DS200SNPAH1ABB version without any configuration changes. Simply swap the boards and power up the system. GE designed this interface board for hot-swappable installation. Hence, you can replace it without shutting down the turbine.
Four PCB layers separate serial traces from power and digital signals. Four connectors handle all power, serial, and backplane communication. The GE DS200SNPAH1A DS200SNPAH1ABB holds 470 µF of capacitance for stable operation. Accordingly, it maintains communication during minor power fluctuations. Four status LEDs show power, transmit, receive, and fault conditions clearly.
Network Configuration and Installation Guide
Selectable termination resistors match the RS-485 network impedance. You enable them via onboard jumpers for end-of-line devices. The GE DS200SNPAH1A DS200SNPAH1ABB works with GE drives, PLCs, and operator interfaces. Always set the correct baud rate before connecting to the network. Four LEDs provide immediate visual feedback for troubleshooting.
Proper grounding of cable shields ensures noise-free serial communication. The board includes optocoupler isolation on both serial ports. The GE DS200SNPAH1A DS200SNPAH1ABB delivers reliable SNP protocol connectivity. Installation requires only a screwdriver for power and serial connections. This board operates in non-condensing environments with adequate ventilation.