GE DS200PTBAG1A DS200PTBAG1ABA Termination Board

Why This Termination Board Streamlines Field Signal Connections

The GE DS200PTBAG1A DS200PTBAG1ABA terminates field wiring for Mark V turbine systems. This board connects sensor signals to the main control rack. It provides a central junction point for analog and discrete inputs. For this reason, the GE DS200PTBAG1A DS200PTBAG1ABA simplifies cabinet layout and maintenance tasks. It also reduces wiring errors by grouping related signals together.

Technical Specifications of the Board

We engineer this GE DS200PTBAG1A DS200PTBAG1ABA for clean signal termination. It operates without an external power supply. The board features eighteen terminal block positions for field wiring. Each terminal accepts 14‑22 AWG copper wires securely. On‑board capacitors filter high-frequency noise from incoming signal lines.

Specification	Value	Additional Notes
Full Model	GE DS200PTBAG1A DS200PTBAG1ABA	Termination Board
Power Supply	Passive operation	No external power needed
Terminal Positions	Eighteen positions	For field wiring connections
Wire Gauge	14‑22 AWG	Solid or stranded copper
Signal Filtering	On‑board capacitor array	Reduces high‑frequency noise
Current Rating	5A per terminal	Maximum continuous current
Voltage Rating	250V AC / 30V DC	Isolation between terminals
Dimensions	210mm x 115mm x 55mm	Fits Mark V termination racks
Weight	0.46 kg (approximately)	Lightweight for easy mounting
Interface Type	Backplane connector + screw terminals	Gold‑plated for reliability
Component Count	30 discrete components	Capacitors and resistors only

Hardware Architecture and Signal Routing

The GE DS200PTBAG1A DS200PTBAG1ABA contains no active electronic components. This board relies on passive filtering for noise reduction. Moving to input side, terminal blocks receive signals from field sensors. The board then routes these signals through filter networks to the backplane connector. Moreover, the G1ABA revision adds basic surge protection components. This improvement guards downstream cards against minor voltage spikes.

Installation and Wire Transfer Guidelines

You must disconnect all field wiring before removing the old board. Label each wire with its corresponding terminal number on the GE DS200PTBAG1A DS200PTBAG1ABA first. Then transfer each wire to the exact same position on the replacement board. Verify all screw terminals tighten securely to prevent signal loss. Skipping this step may cause intermittent sensor readings. Additionally, inspect all filter capacitors for visible damage before installation.