GE A06B-6058-H222 AC Servo Drive Unit

Precision Motor Control for CNC Applications

The GE A06B-6058-H222 regulates three-phase AC servo motor velocity and position. This drive pairs directly with Red Cap series motors. It delivers smooth torque across a wide speed range. Consequently, machine tools achieve precise contouring and rapid positioning.

Main Technical Parameters

This drive unit measures 300 mm in height by 70 mm in width. The GE has a depth of 210 mm. It weighs approximately 3.2 kg. The unit contains a single main power board and one regulator board. A built-in cooling fan supports continuous operation at high loads.

The drive stores no user-configurable parameters internally. It relies on the CNC controller for all motion commands. Furthermore, the GE A06B-6058-H222 includes two 20-pin connectors for encoder feedback. One 6-pin terminal block handles three-phase AC input power.

Power Ratings and Output Characteristics

The GE A06B-6058-H222 operates from 200V to 230V AC input at 50/60 Hz. It provides a continuous output current of 12 amps. The peak output current reaches 24 amps for short durations. Therefore, this drive handles high torque demands during acceleration. The unit achieves a PWM switching frequency of 8 kHz. This setting reduces audible motor noise significantly.

Interface and Feedback System

Moreover, this drive accepts differential encoder signals up to 200 kHz. It also monitors motor over-temperature through dedicated thermostat inputs. The GE A06B-6058-H222 generates a brake control output for holding applications. Six status LEDs indicate power, ready, and fault conditions. These lights help technicians troubleshoot without external tools.

Environmental and Mounting Requirements

The unit operates reliably from 0°C to 55°C ambient temperature. It requires 150 mm of clearance above and below for airflow. The GE A06B-6058-H222 meets IP10 protection for indoor use. Consequently, install this drive inside a sealed control cabinet.