Schneider A010/24V | PLC Module Compact Power

The Schneider A010/24V combines power regulation and basic logic control functions. This PLC module operates as part of smaller Schneider automation systems. You can find it inside legacy control panels and compact machinery. The unit converts AC input into stable 24 VDC for internal circuits.

Power and Electrical Specifications

Parameter	Specification
Brand	Schneider Electric
Model	A010/24V
Product Type	PLC Module (Power + Logic)
Input Voltage	100 to 240 VAC (47-63 Hz)
Output Voltage	24 VDC nominal
Output Current	1.2 A maximum
Output Power	28 W continuous
Efficiency	78% typical
Ripple & Noise	< 60 mV peak-to-peak
Logic Processing	Basic relay replacement logic

The Schneider A010/24V accepts worldwide AC input without manual switching. This PLC module delivers 1.2 amps at 24 VDC for powering small loads. You can rely on its simple logic for basic machine sequencing. The output ripple stays below 60 mV for reliable digital operation.

Physical Dimensions and Weight

Parameter	Specification
Weight	0.22 kg (0.49 lbs)
Length	145 mm
Width	85 mm
Height	32 mm
PCB Layers	2 (FR4 material)
Component Count	94 discrete parts
Mounting Holes	4 (M3 clearance)

This PLC module weighs only 0.22 kg for easy handling during replacement. The board measures 145 mm long by 85 mm wide. Its height reaches 32 mm including tallest components. You can mount the Schneider A010/24V using four M3 screws through the corner holes.

Connectors and Interface Points

A 14-pin right-angle header connects to the main backplane or motherboard. One 4-pin Molex connector handles DC output and status signals. You will also find one 3-pin terminal block for AC input wiring. The board includes two 2-pin connectors for discrete input and output signals. All connectors use tin-plated contacts for reliable conductivity.

Energy Storage and Capacitive Bank

The Schneider A010/24V stores moderate energy for short brownout ride-through. Two electrolytic capacitors provide 680 µF of total bulk storage. These capacitors maintain 24 VDC output for 15 ms after input power drops. Additionally, eight ceramic capacitors filter high-frequency switching noise. The board does not contain any battery for long-term memory retention.

Internal Components and Circuit Layout

A small switching transformer operates at 50 kHz for power conversion. The primary side includes a power MOSFET and simple PWM controller. You will find 28 resistors, 24 capacitors, and 8 diodes on the board. Two optocouplers provide feedback isolation between primary and secondary circuits. The Schneider A010/24V includes a slow-blow fuse rated at 1.6 A, 250 V.

Regulation and Protection Features

This PLC module includes overcurrent protection at 1.5 A typical. The device also features short-circuit protection with automatic retry. An overtemperature sensor shuts down the unit at 80°C internal temperature. The output includes a crowbar circuit for overvoltage protection at 28 VDC. Transitioning to this module restores power and basic logic functions simultaneously. For best results, verify adequate ventilation around the board during operation.