GE IS200TTURH1B IS200TTURH1BED Turbine Termination Board

The GE IS200TTURH1B IS200TTURH1BED Turbine Termination Board provides a centralized wiring hub for turbine field devices. You will find this board essential for organizing sensor and actuator connections. Its passive design requires no external power for signal routing.

Dimensions, Weight, and Mechanical Layout

This turbine termination board measures 21.0 cm in length and 15.5 cm in width. Its height reaches 4.0 cm including all screw terminal blocks. The total weight stands at 0.63 kilograms for secure DIN-rail mounting. A heavy-duty fiberglass PCB withstands high vibration environments effectively.

Terminal Interfaces and Component Count

The GE IS200TTURH1B IS200TTURH1BED Turbine Termination Board offers thirty-two independent screw terminal connections. Each terminal accepts 14 to 24 AWG solid or stranded wire. You also receive four dedicated shield terminals for noise reduction. In total, this board contains 118 individual electronic components. These include 32 terminal blocks, 16 jumper headers, and 48 transient suppression diodes.

Signal Routing and Filtering Features

A passive signal routing matrix connects field wiring to ribbon cable headers. Each signal path includes a 100-ohm series resistor for current limiting. The board also features RC filters on eight critical input channels. These filters reject 60 Hz noise from industrial power lines.

Environmental Limits and Wiring Specifications

Therefore, the operating temperature ranges from -40°C to +75°C. Storage temperatures extend from -55°C to +85°C without degradation. Maximum terminal current rating reaches 5 amperes per connection. Voltage rating stands at 300V AC or DC between adjacent terminals.

Below table summarizes all key technical parameters:

Parameter	Value
Manufacturer	General Electric
Series	Mark VI IS200
Full Product Name	GE IS200TTURH1B IS200TTURH1BED Turbine Termination Board
Model Numbers	IS200TTURH1B, IS200TTURH1BED
Length	21.0 cm
Width	15.5 cm
Height	4.0 cm
Weight	0.63 kg
PCB Material	Heavy-duty fiberglass
Mounting Type	DIN-rail
Independent Screw Terminals	32
Shield Terminals	4
Wire Gauge Range	14 to 24 AWG
Total Components	118
Terminal Blocks	32
Jumper Headers	16
Transient Suppression Diodes	48
Signal Path Series Resistor	100 ohms
RC Filtered Channels	8
Noise Rejection Frequency	60 Hz
Power Requirement	None (passive)
Maximum Terminal Current	5 A
Voltage Rating	300V AC/DC
Operating Temperature	-40°C to +75°C
Storage Temperature	-55°C to +85°C

Connectors, Cabling, and Additional Features

Three 40-pin ribbon cable headers connect to turbine control and protection boards. A single ground stud provides chassis earth connection point. For similar static trip system termination, see the RMS-TSG-TZ-C model from the same manufacturer. However, this turbine termination board specializes in centralized field wiring exclusively. Mean time between failures (MTBF) exceeds 300,000 hours due to passive construction.