MeloAuto-Trusted PLC & DCS Parts Supplier
The 170180-01-00 external transducer I/O module from Bently Nevada connects field sensors to machinery protection racks through remote wiring. Plant engineers install this module whenever transducers sit far from the monitor cabinet. Consequently, it delivers conditioned signals over long cable runs without losing measurement accuracy.
Key Technical Specifications
The table below outlines the main physical and electrical parameters of the 170180-01-00 module.
| Parameter | Specification |
|---|---|
| Product Type | External Transducer I/O Module |
| Compatibility | Bently Nevada machinery protection systems |
| Dimensions | Approximately 200 mm x 130 mm x 40 mm |
| Weight | Approximately 0.7 kg (1.5 lbs) |
| Mounting | Panel or field enclosure mounting base |
| Interface | Backplane bus and external transducer terminals |
| Connectors | Multi-pin connector and terminal blocks |
| Component Count | Multiple signal conditioners, filters, and driver circuits |
| Energy Storage | On-board capacitors for signal and voltage stabilization |
| Input Channels | Multiple external transducer input channels |
| Signal Type | Proximity probe and accelerometer input support |
| Operating Temperature | 0 degrees C to 60 degrees C |
| Storage Temperature | -40 degrees C to 85 degrees C |
| Humidity | 5% to 95% non-condensing |
Functional Overview
This module receives transducer signals at a remote location and forwards them to the protection rack. Therefore, it shortens field wiring runs and reduces installation costs across large machine trains. The 170180-01-00 also conditions each signal before transmission to preserve measurement accuracy. Meanwhile, its onboard energy storage stabilizes signals during transient voltage fluctuations.
Installation and Handling Notes
Always verify transducer gap voltages before connecting sensors to the 170180-01-00. In addition, use shielded twisted-pair cable to protect signal integrity over long runs. Tighten all connectors fully to prevent intermittent data loss. Finally, confirm channel readings during commissioning.