MeloAuto-Trusted PLC & DCS Parts Supplier
The 106765-25 Velomitor XA interconnect cable from Bently Nevada links velocity sensors to machinery protection racks over long cable runs. Plant engineers order this cable whenever a transducer sits far from its monitor position. Consequently, it carries low-level vibration signals without losing accuracy or picking up electrical noise.
Key Technical Specifications
The table below outlines the main physical and electrical parameters of the 106765-25 cable.
| Parameter | Specification |
|---|---|
| Product Type | Velomitor XA Interconnect Cable |
| Compatibility | Bently Nevada Velomitor and machinery protection systems |
| Cable Length | 25 feet (approximately 7.6 metres) |
| Weight | Approximately 0.4 kg (0.88 lbs) |
| Mounting | Cable clamps and conduit routing |
| Interface | Coaxial connector to sensor and monitor |
| Connectors | Coaxial connectors on both ends |
| Component Count | Cable conductor, shield, insulation, and connectors |
| Energy Storage | Not applicable for this passive cable assembly |
| Signal Type | Low-level vibration signal transmission |
| Shielding | Braided shield against electrical interference |
| Operating Temperature | -40 degrees C to 120 degrees C |
| Storage Temperature | -40 degrees C to 85 degrees C |
| Humidity | 5% to 95% non-condensing |
Functional Overview
This cable carries vibration signals from the sensor to the monitor rack input. Therefore, it preserves signal strength and timing across the full cable length. The 106765-25 also shields the conductor against electrical noise from nearby power wiring. Meanwhile, its connectors mate securely with standard Bently Nevada sensor and rack ports.
Installation and Handling Notes
Always route the 106765-25 away from motor and power cabling to reduce interference. In addition, secure the cable with clamps so it cannot flex during machine operation. Bend the cable only within the specified radius. Finally, verify signal integrity after installation.